Ge ZKD910SFSS Instrukcja Użytkownika

Installation Instructions27” and 30” Warming DrawersModels:ZKD910ZTD910

10TOOLS AND MATERIALS REQUIRED• Phillips screwdriver• Drill and appropriate bits (Brad point recommended for drilling through wood panels)• Custom pa

11 SECURE CUSTOM PANEL TO METAL MOUNTING PANEL• Lay the custom panel, appearance side down, on a clean surface. • Place the flat side of the metal

12 REMOVE ORIGINAL DRAWER FRONT• Remove the three screws from the bottom of the drawer edge.• Remove the four screws on the inside of the drawer at

13Notes

Notes14

Notes15

NOTE: While performing installations described in this book, safety glasses or goggles should be worn.For Monogram® local service in your area, call

2BEFORE YOU BEGIN Read these instructions completely and carefully.• IMPORTANT³ Save these instructions for local inspector’s use. • IMPORTANT³ O

CONTENTSDesign InformationModels Available ...3Accessories ...

4PRODUCT DIMENSIONS AND CLEARANCESDesign Information9”10-1/2”ABC1”Including HandleDrawer Open23-1/4”Dimensions A B C ZTD910 22” 26” 30” ZTD910 w/

Design Information5GROUNDING THE APPLIANCEPlease read carefully.FOR PERSONAL SAFETY, THIS APPLIANCE MUST BE PROPERLY GROUNDED. Do not use an extension

6Installation PreparationTOOLS REQUIREDSafety GlassesDrill and 1/16” BitMeasuring TapePhillips ScrewdriverHand SawMATERIALS REQUIRED (provided)MATERI

7Installation PreparationNOTE: Additional clearance between cutouts may be required. Check to be sure that oven supports above the Warming Drawer lo

8Installation PreparationINSTALLATION BELOW A COUNTERTOP*NOTE: When installing the warming drawer below a cooktop, a solid barrier must be installed a

WARNINGANTI-TIP PRECAUTIONSAn anti-tip brace must be installed to prevent the drawer from tipping forward when opened and loaded. Failure to do so cou