GE ZPBS360 Instrukcja Użytkownika Pobierz pdf

BEFORE YOU BEGIN

Read these instructions completely and carefully.

• Note to Installer – Be sure to leave these

instructions with the Consumer.

• Note to Consumer – Keep these instructions with

your Owner’s Manual for future reference.

Installation

Instructions

ACCESSORY PANEL KITS

ZPSS360 – Stainless Steel

ZPBS360 – Black Acrylic

Kit Contents

• 2 Filler panels

(with ZPSS360 only)

• Door panel

• Grille panel

Tools Required

• Phillips screwdriver

• Safety glasses

• Gloves to protect against

sharp edges

• Wood block

• Hammer

REMOVE HANDLES AND TRIM

• Open the door to 90°. Remove the 6 Phillips head

screws from the door handle.

• Remove handle. Retain all screws.

• Remove 6 screws holding trim. Lift off trim.

Retain screws.

STEP 1

INSTALL PANELS

• Remove protective film from appearance panel.

• Slide panel into the door trim.

• If installing stainless steel panels, first slide filler

panel into the door trim, then slide stainless panel

into the trim.

• If necessary, tap with a wood block until panel slips

under the hinge side trim.

• There are two sets of holes in the handle side trim.

Replace side trim by installing the original screws

in the FRONT screw holes.

• Secure the handle to the door using the REAR

screw holes.

STEP 2

Use Rear Holes

to Secure Handle

Use Front Holes

to Secure Trim

1 2

Podsumowanie treści

Strona 1 - Instructions

BEFORE YOU BEGIN Read these instructions completely and carefully.• Note to Installer – Be sure to leave theseinstructions with the Consumer.• Note to

Strona 2 - INSTALL GRILLE PANEL

INSTALL GRILLE PANEL• Remove the protective film from the appearance panel.• Raise the grille panel to the stop position.• Loosen the screws on the si