GE JGP333SETSS Instrukcja Obsługi

Przeglądaj online lub pobierz Instrukcja Obsługi dla Kuchenki GE JGP333SETSS. GE JGP333SETSS Instructions / Assembly Instrukcja obsługi

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 32
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 0
1
31-10835 (11-11 GE)
BEFORE YOU BEGIN
Read these instructions completely
and carefully.
IMPORTANT Save these instructions
for local inspector’s use.
IMPORTANT Observe all governing
codes and ordinances.
Note to Installer – Be sure to leave these
instructions with the Consumer.
Note to Consumer – Keep these instructions for
future reference.
Product failure due to improper installation is not
covered under the Warranty.
WARNING This appliance must be
properly grounded.
IMPORTANT Leak testing of the
appliance shall be conducted according to the
manufacturer’s instructions.
Proper installation is the responsibility of the
installer and product failure due to improper
installation is NOT covered under warranty.
IN THE COMMONWEALTH OF
MASSACHUSETTS:
This product must be installed by a licensed
plumber or gas fitter.
When using ball-type gas shut-off valves, they
shall be the T-handle type.
A flexible gas connector, when used, must not
exceed 3 feet.
Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: ge.com
In Canada, call 1.800.561.3344 or Visit our Website at: www.geappliances.ca
Installation
30 Sealed Gas Cooktop
Instructions
JGP329, JGP333, JGP940, PGP943
FOR YOUR SAFETY:
WARNING If the information
in this manual is not followed exactly, a fire,
explosion or gas leak may result causing property
damage, personal injury or death.
Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this or any other
appliance!
WHAT TO DO IF YOU SMELL
GAS:
Do not try to light any appliance. Do not touch
any electrical switch; do not use any phone in
your building.
Immediately call your gas supplier from a
neighbor’s phone. Follow the gas supplier’s
instructions.
If you cannot reach your gas supplier, call the fire
department.
Installation and service must be performed
by a qualified installer, service agency or
the gas supplier.
This cooktop has been design certified
by CSA International. You’ll find safety precautions
in your Owner’s Manual.
Read them carefully.
Installation of this cooktop must conform with
local codes or in the absence of local codes with
the National Fuel Gas Code, ANSI Z223.1/NFPA
54–Latest edition.
Be sure your cooktop is installed properly by a
qualified installer or service technician.
To eliminate reaching over surface burners,
cabinet storage above burner should be avoided.
Do not install the unit near an outside door or
where a draft may affect its use.
WARNING Disconnect all electrical
power at the main circuit breaker
or fuse box before installing.
Przeglądanie stron 0
1 2 3 4 5 6 ... 31 32

Podsumowanie treści

Strona 1 - Instructions

131-10835 (11-11 GE)BEFORE YOU BEGINRead these instructions completely and carefully.• IMPORTANT — Save these instructions for local inspector’s us

Strona 2

10Installation Instructions1ASSEMBLING THE COOKTOP BURNERSThe electrode of the spark igniter is exposed. Be careful not to push any cooktop controls w

Strona 3

11Installation Instructions5BURNER GRATESThe four cooktop grates are designed for specific positions. For maximum stability, these grates should only

Strona 4

OPERATION CHECKLISTAMake sure all controls are left in the OFF position. Check to be sure the cooktop is in the UNLOCKED position (on models so equipp

Strona 5

13Installation InstructionsMAKING THE LP CONVERSION1SAFETY INFORMATION YOU SHOULD KNOW The pressure regulator and burner orifices are set for natural

Strona 6

14Installation InstructionsMAKING THE LP CONVERSION (CONT.)3CHANGE COOKTOP BURNER ORIFICESARemove the top grates, burner caps, and burner heads.BRemov

Strona 7

15Installation InstructionsEInstall the LP/Propane orifices in their precise locations as noted in the illustrations above.FReturn the natural gas ori

Strona 8

16Installation InstructionsMAKING THE LP CONVERSION (CONT.)4ADJUST BURNER FLAMESATurn all burners full on and check the flames. They should be blue in

Strona 9

131-10835 (11-11 GE)BEFORE YOU BEGINRead these instructions completely and carefully.• IMPORTANT — Save these instructions for local inspector’s us

Strona 10 - COOKTOP BURNERS

2Installation InstructionsIMPORTANT SAFETY INSTRUCTIONSELECTRICAL REQUIREMENTSThis appliance must be supplied with the proper voltage and frequency an

Strona 11

3Installation InstructionsAWhen preparing cooktop opening, make sure the inside of the cabinet and the cooktop do not interfere with each other. (See

Strona 12 - OPERATION CHECKLIST

2Installation InstructionsIMPORTANT SAFETY INSTRUCTIONSELECTRICAL REQUIREMENTSThis appliance must be supplied with the proper voltage and frequency an

Strona 13 - MAKING THE LP CONVERSION

4Installation InstructionsPREPARING THE OPENING 1MAINTAIN THE FOLLOWING MINIMUM CLEARANCE DIMENSIONS3 3/4 MIN.4RECOMMENDED GAS SUPPLY LOCATION FROM BA

Strona 14

5Installation InstructionsINSTALLING THE COOKTOP UNIT1LOCATE ELECTRICAL OUTLET AND GAS SHUT-OFF VALVE BENEATH CABINETInstall a manual shut-off valve i

Strona 15

6Installation InstructionsINSTALLATION—GAS CONNECTIONS 1PROVIDE ADEQUATE GAS SUPPLYThis cooktop is designed to operate on natural gas at 4″ of water c

Strona 16

7Installation Instructions6INSTALLATION OVER BUILT-IN OVENSee built-in oven installation for complete installation instructions.5″ To Center of 2″ Dia

Strona 17

8Installation Instructions1EXTENSION CORDSBecause of potential safety hazards under certain conditions, we strongly recommend against the use of an ex

Strona 18 - IMPORTANT SAFETY INSTRUCTIONS

9Installation Instructions4USAGE SITUATIONS WHERE APPLIANCE POWER CORD WILL BE DISCONNECTED INFREQUENTLYFor 15 amp circuit only. Do not use an adapto

Strona 19 - PRE-INSTALLATION CHECKLIST

10Installation Instructions1ASSEMBLING THE COOKTOP BURNERSThe electrode of the spark igniter is exposed. Be careful not to push any cooktop controls w

Strona 20 - PREPARING THE OPENING

11Installation Instructions5BURNER GRATESThe four cooktop grates are designed for specific positions. For maximum stability, these grates should only

Strona 21 - INSTALLING THE COOKTOP UNIT

OPERATION CHECKLISTAMake sure all controls are left in the OFF position. Check to be sure the cooktop is in the UNLOCKED position (on models so equipp

Strona 22 - INSTALLATION—GAS CONNECTIONS

13Installation InstructionsMAKING THE LP CONVERSION1SAFETY INFORMATION YOU SHOULD KNOW The pressure regulator and burner orifices are set for natural

Strona 23

3Installation InstructionsAWhen preparing cooktop opening, make sure the inside of the cabinet and the cooktop do not interfere with each other. (See

Strona 24

14Installation InstructionsMAKING THE LP CONVERSION (CONT.)3CHANGE COOKTOP BURNER ORIFICESARemove the top grates, burner caps, and burner heads.BRemov

Strona 25

15Installation InstructionsEInstall the LP/Propane orifices in their precise locations as noted in the illustrations above.FReturn the natural gas ori

Strona 26

16Installation InstructionsMAKING THE LP CONVERSION (CONT.)4ADJUST BURNER FLAMESATurn all burners full on and check the flames. They should be blue in

Strona 27

4Installation InstructionsPREPARING THE OPENING 1MAINTAIN THE FOLLOWING MINIMUM CLEARANCE DIMENSIONS3 3/4 MIN.4RECOMMENDED GAS SUPPLY LOCATION FROM BA

Strona 28

5Installation InstructionsINSTALLING THE COOKTOP UNIT1LOCATE ELECTRICAL OUTLET AND GAS SHUT-OFF VALVE BENEATH CABINETInstall a manual shut-off valve i

Strona 29

6Installation InstructionsINSTALLATION—GAS CONNECTIONS 1PROVIDE ADEQUATE GAS SUPPLYThis cooktop is designed to operate on natural gas at 4″ of water c

Strona 30

7Installation Instructions6INSTALLATION OVER BUILT-IN OVENSee built-in oven installation for complete installation instructions.5″ To Center of 2″ Dia

Strona 31

8Installation Instructions1EXTENSION CORDSBecause of potential safety hazards under certain conditions, we strongly recommend against the use of an ex

Strona 32

9Installation Instructions4USAGE SITUATIONS WHERE APPLIANCE POWER CORD WILL BE DISCONNECTED INFREQUENTLYFor 15 amp circuit only. Do not use an adapto

Komentarze do niniejszej Instrukcji

Brak uwag