Ge 45613 GE Z-Wave 3-Way Dimmer Kit with Terminals Instrukcja Użytkownika

GE SmartHome™Wireless Lighting ControlOn/Off/Dim Dimmer Switch45612(ZW3003)/45613(ZW3003 & ZW2002)Z-Wave® Certified Wireless Lighting Control

White (Neutral) Z-Wave 45610 Z-Wave 45612 Black (Line / Hot) Black (Load) Traveler - Colored (Not Green) Green (Ground) White (Neutral) Z-Wave 456

Single, Dual and Triple Gang Boxes The metal plate surrounding the switch assembly is a heat sink. The maximum load rating (600W) is provided when in

SHOCK HAZARD! Turn OFF the power to the branch circuit at the circuit breaker in your electrical service panel. Ensure power is OFF before you instal

8.Connect the black wire that goes to the light to the terminal marked LOAD.9. Connect the black wire that comes from the electrical service panel (Ho

Observe Important Wiring Information Important: This switch is rated for and intended to only be used with copper wire. The home’s electrical wires

normal operation. The air gap switch must be all the way in for the switch to function and control the lighting.Key Features• Remote On/Off/Brightnes

pressing and holding the rocker until the light intensity is at the minimum setting does not turn the power OFF; you must still tap (press & relea

ADVANCED OPERATIONThe following Advanced Operation parameters require that you have an advanced controller like the GE model 45601 LCD remote. Advanc

Invert SwitchIf the switch is accidentally installed upside down with “On” at the bottom and “Off” at the top, the default On/Off rocker settings can

• Parameter 12 (timing of the steps)• Length: 1 Byte• Valid Values:Parameter 11 (default = 1) Valid Values: 1-99Parameter 12 (default = 3) Valid Value

Introduction:Thank you for your purchase of a GE Z-Wave® control device. Z-Wave technology is designed to automate lighting/home control and provide

gives you specific rights, and you may also have other rights which vary from state to state. Please contact Customer Service at 800-654-8483 (option

Operation is subject to the following two conditions:- This device may not cause interference - This device must accept any interference, including in

is a registered trademark of General Electric Company and is used under license to Jasco Products Company LLC, 10 E Memorial Rd., Oklahoma City, Okl

This device is intended for installation in accordance with the National Electric Code and local regulations in the United States, or the Canadian Ele

RISK OF FIRERISK OF ELECTRICAL SHOCKRISK OF BURNSWARNINGControlling Appliances:Exercise extreme caution when using Z-Wave devices to control appliance

Wireless RangeThis device complies with the Z-Wave standard of open-air, line of sight transmission distances of 65 feet. Actual performance in a hom

Effects of Home Construction on Wireless Range Between Z-Wave Enabled Devices.Note: The distances shown in the table below are typical examples. Actu

Please Note: Z-Wave home control networks are designed to work properly alongside 802.11 wireless computer networks, Bluetooth and 2.4GHz, 5.8GHz or

Other color White Z-Wave Auxiliary Z-Wave Primary Black Black (Line / Hot) Black (Line / Hot) White White (Neutral) Black (Load) White Z-Wave P

Please consult an electrician if you have trouble identifying the type of wiring circuit you wish to convert or if you do not feel confident in your ab