GE GE24STACK Instrukcja Instalacji Strona 2

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 2
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 1
INSTALLINGTHESTACKBRACKETKIT
LAYTHEDRYERONITSSIDE
A.Carefullylaythedryeronitsside.Usethe
packingmaterialsoyoudon’tscratchthenishon
the dryer.
INSTALLRUBBERPADS
A.Locatethe4rubberpadsinthepartspackage.
InsertrubberpadsintotheLEG.
B.Set the dryer upright.
INSTALLBRACKETTODRYER
A.Remove washer top cap screw from the rearleft.
Alignleftbracketholeswithtopcapscrewholeon
rear left of the unit and replace screw.
NOTE:Leave screw loose so dryer hole alignment
will be easier.
B.Repeat the above step with the right side.
INSTALLDRYERANDBRACKETONWASHER
A.Liftthedryerontopofthewasher.Protectthe
washer control panel with cardboard or other protec-
tion. Be sure to lift the dryer high enough to clear the
washer control panel.
WARNING–Potential
PersonalInjury.Morethantwopeoplearerecom-
mendedtoliftthedryerintopositionbecauseof
itsweightandsize.Failuretodosocouldresultin
personalinjuryordeath.
B.Aligntheholesinthebracketwiththeholesinthe
backofthedryer.UsingaPhillipsscrewdriver,attach
the 4x12mm tapping screws.
C.Tightenthewasherbracketscrews;thentighten
allstackingkitscrews.
FINALIZETHEINSTALLATION
A.RefertothewasherInstallationInstructions
to complete the washer installation.
B.RefertothedryerInstallationInstructionsto
complete the dryer installation.
C.Carefullyslideorwalkthestackedwasherand
dryerintoplace.Usefeltpadsorotherslidingdevice
toassistmovingandtoprotectooring.
WARNING–PotentialPersonal
Injury.Donotpushonthedryeronceinstalledto
topofthewasher.Pushingonthedryermayresult
inpinchedngers.
DC68-02772D
GE24STACKINSTALLATIONINSTRUCTIONS
(WCVH48**K&DCCH48**KONLY)
Przeglądanie stron 1
1 2

Komentarze do niniejszej Instrukcji

Brak uwag