GE PT878GC Instrukcja Użytkownika Pobierz pdf (Strona 41)

100

101

3-9

April 2004

Installing the V Series Clamping Fixture

and Transducers

Note: A complete installation involves the clamping fixture,

transducers and dampening material. If you are using

dampening material, refer to Installing Dampening

Material on page 3-21.

To install the V Series clamping fixture and transducers,

complete the following steps:

Installing the Fixture

1. Position the half of the clamping fixture with the threaded

rods around the pipe, as shown in Figure 3-7 below. Orient the

fixture in the 3 o’clock position on a horizontal pipe.

2. Position the mating half of the fixture over the threaded rods

in the 9 o’clock position. Figure 3-7 below shows the two

mounted halves.

Note: If you are using a V4 fixture with a 1.5 to 2-in. pipe, GE

Panametrics suggests removing the nut and the mounting

bracket, rotating it 180° and replacing the bracket and

nut for a more secure fit.

Figure 3-7: Mounting the Two Halves of the Fixture

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 307 308

Komentarze do niniejszej Instrukcji

Brak uwag

GE PT878GC Instrukcja Użytkownika Strona 41

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Pomiary, testowanie i kontrola GE PT878GC