Ge 45610WB GE Z-Wave Add On Auxiliary Switch Instrukcja Użytkownika Strona 1

45610/ZW2001/ZW2002 GE Wireless Lighting Control Auxiliary Switch

Z-Wave 45607, 45609 or 456121. Shut off power to the circuit at fuse box or circuit breaker.2. Remove wall plate. ! Warning: Verify power is OFF to

10. Connect the black wire that comes from the electrical service panel (Hot) to the lead or terminal marked LINE.11. Connect the Traveler wire (usual

Observe Important Wiring Information Important: This switch is rated for and intended to only be used with copper wire. Models 45609 and 45612 ONLY:

the brightness level of the connected lighting. Release when the desired level is attained.When installed with the 45609 switch:• Press and release t

WARRANTYJASCO Products warrants this product to be free from manufacturing defects for a period of two years from the original date of consumer purcha

45603-2 rev. 1/21/11

ZW2002Specications subject to change without notice due to continuing product improvementZ-Wave is a registered US trademark of Sigma Designs© 2010 J

This auxiliary switch is a component of the GE Z-Wave® lighting control system and is designed to work with the 45607 Dimmer (ZW3002), 45612 Dimmer (Z

This device is intended for installation in accordance with the National Electric Code and local regulations in the United States, or the

continuedFor these reasons, we recommend the following:1. Assign Z-Wave controlled appliances to device numbers 10 – 18 on the GE remote. The likeli

IMPORTANT NOTE ABOUT 3-WAY CIRCUITSThe term “3-way circuit” refers to a circuit with two switches and one load (light) like you nd at the top and bot

Typical 3-way circuit:Wrong Z-Wave switch position for typical 3-way circuit; Colored (NOT GREEN) Black Black Black White Switch 1 Switch 2 Black

Correct Z-Wave switch position for typical 3-way circuit: Colored (NOT GREEN) Black Black Black White Switch 1 Switch 2 Black (Line / Hot) Black (L

INSTALLATIONThis switch may be used in new installations or to replace an existing wall switch when converting a 3 or 4 way circuit to Z-Wave. It can

White (Neutral) Z-Wave 45610 Z-Wave 45607, 45609 or 45612* Black (Line / Hot) Black (Load) Traveler - Colored (Not Green) Green (Ground) * The 45612