Ge 45610WB GE Z-Wave Add On Auxiliary Switch Instrukcja Użytkownika Pobierz pdf (Strona 5)

IMPORTANT NOTE ABOUT 3-WAY CIRCUITS

The term “3-way circuit” refers to a circuit with two switches

and one load (light) like you nd at the top and bottom of a

stairway. There are many ways to physically wire a 3-way

circuit and it is important to understand how the circuit you

wish to upgrade to Z-Wave control is wired. Below is a

description of a typical 3-way circuit.

One of the ways to wire a two-switch/one-load circuit is

to route the incoming power through the rst switch, then

to the second switch and then to the load. Although very

common and by no means a standard, it is the easiest to

convert to Z-Wave control. With this type of circuit, Switch

1 is replaced by the Z-Wave auxiliary switch and Switch 2

is replaced with the primary Z-Wave switch. The auxiliary

switch does not actually control the power; instead, it sends

a momentary voltage signal through the traveler wire to the

primary switch which in turn, controls the power to the load.

1 2 3 4 5 6 7 8 9 10 ... 15 16

Brak uwag

Ge 45610WB GE Z-Wave Add On Auxiliary Switch Instrukcja Użytkownika Strona 5